Add HS20TermsAndConditions signal to D-Bus API to allow clients to be
notified when the network requires the acceptance of terms and
conditions. The URL of the T&C page is provided as a signal parameter.
Signed-off-by: Damien Dejean <damiendejean@chromium.org>
The ps command as shipped by busybox does not support the "command"
column. Change the code to use pgrep instead which will work fine in all
environments.
In addition, raise an exception if PID was not found since the test
would just hang with pid = 0.
Signed-off-by: Benjamin Berg <benjamin.berg@intel.com>
Avoid race conditions (especially with UML time travel) between AP
completion of 4-way handshake and traffic test.
Signed-off-by: Jouni Malinen <j@w1.fi>
The test cases that used country code ZA for the actual test on the 5
GHz band ended up failing in some cases due to various race conditions
with the initial AP start on the 5 GHz band using country code US.
Reduce the risk for that type of failures by using the same country code
ZA for both AP starts.
Signed-off-by: Jouni Malinen <j@w1.fi>
Add a test that runs the cfg80211/mac80211 kunit tests (they must be
built as modules to run at this point), and checks the results. The test
is skipped if all the modules fail to load.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Add tests for new response handling logic:
1. Verify MSCS change response handling in association / action frame.
2. Verify MSCS unsolicited response handling.
Signed-off-by: Daniel Gabay <daniel.gabay@intel.com>
It looks like the first broadcast frame might be missed in some cases,
so increase the timeout here to allow another round of frames to be
attempted.
Signed-off-by: Jouni Malinen <j@w1.fi>
fils_offload_to_driver2 and wpas_config_file_key_mgmt require
CONFIG_FILS=y, but they did not use check_fils_capa().
Signed-off-by: Jouni Malinen <j@w1.fi>
Verifying that the station can successfully associate again
after being deauthenticated or disassociated.
Signed-off-by: Ilan Peer <ilan.peer@intel.com>
This triggers a kmemleak scan between tests. This allows finding memory
leaks and doing this should attribute the leak to the correct test in
most cases. Note that it does add a sleep after each test, as such it is
most sensible when combined with UML time-travel.
Signed-off-by: Benjamin Berg <benjamin.berg@intel.com>
We need the station to be fully set up on the AP before
running the connectivity check, not just the station to
be set up itself. Just waiting for the events seems to
still be racy so just sleep a little bit.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Appending to a bytes() object is rather inefficient. As such, avoid
doing so by first creating a list and then joining all buffers together
at the end only.
Signed-off-by: Benjamin Berg <benjamin.berg@intel.com>
_FORTIFY_SOURCE requires at least -O2 optimization level.
This may result in compilation warnings. Fix it.
Signed-off-by: Andrei Otcheretianski <andrei.otcheretianski@intel.com>
It is possible to execute the tests directly inside the a VM without
necessarily running the repository wrapper script to do so. In these
cases, passing the VM flag using an environment variable allows
correctly flagging this fact to the tests.
Signed-off-by: Benjamin Berg <benjamin.berg@intel.com>
The regulatory domain cannot be reset while the AP is still active. Add
the appropriate commands to bring down the AP after the test, which will
also make resetting the regulatory domain work.
Signed-off-by: Benjamin Berg <benjamin.berg@intel.com>
pyrad does an internal call to getaddrinfo with the service "www".
Make sure this service is known by writing an appropriate
/etc/services file.
Signed-off-by: Benjamin Berg <benjamin.berg@intel.com>
pyrad internally uses socket.getaddrinfo. While it is documented that
one can pass an empty string to bind to all interfaces. The underlying
function expects None instead though, breaking the call.
Either way, it does not hurt to set the bind address to 127.0.0.1
explicitly, so do so to avoid issues.
Signed-off-by: Benjamin Berg <benjamin.berg@intel.com>
It seems that the messages from ip may have a trailing space in some
cases, which may break matching in surrounding logic. Strip the output
to remove whitespace and avoid any issues this may cause.
Signed-off-by: Benjamin Berg <benjamin.berg@intel.com>
Extend the previously used minimal test case with full validation of the
selected channel and connection since hostapd now has support for the
HT40- case as well.
Signed-off-by: Jouni Malinen <j@w1.fi>
With UML time-travel, it was possible for a GAS frame to end up in the
capture file for the next test case and if that next case used tshark to
count the number of frames (which is done, e.g., in
gas_anqp_address3_assoc), the following test case could have indicated
failure even when everything worked correctly.
Signed-off-by: Jouni Malinen <j@w1.fi>
The cfg80211 default QoS mapping might be updated to align with the
recommendations in section 4 in RF C8325. Align the QoS mapping tests
accordingly. For now, allow both the previous and new mapping to pass
the test.
Signed-off-by: Ilan Peer <ilan.peer@intel.com>
Add a simple test that exemplifies TX power configuration when operating
on the 6 GHz band.
Signed-off-by: Ilan Peer <ilan.peer@intel.com>
Signed-off-by: Andrei Otcheretianski <andrei.otcheretianski@intel.com>
Some of these can take close to the previously used timeouts and this
could result in reporting failures in cases that worked fine.
Signed-off-by: Jouni Malinen <j@w1.fi>
Test EHT connection on the 5 GHz band with channel bandwidths 20-160 MHz
and up to 320 MHz on the 6 GHz band.
Signed-off-by: Ilan Peer <ilan.peer@intel.com>
Signed-off-by: Andrei Otcheretianski <andrei.otcheretianski@intel.com>
This avoids issues with old scan results from a previous test causing
incorrect association after WPS exchange.
Signed-off-by: Jouni Malinen <quic_jouni@quicinc.com>
The previous timeout allowed only a single chirping round, and sometimes
not even that full round. That resulted in test failures for cases where
there was not really any incorrect behavior.
Signed-off-by: Jouni Malinen <quic_jouni@quicinc.com>
Stop dev[0] from trying to associate at the end of the test case to
reduce risk for leaving out some pending operations that could mess up
the following test case.
Signed-off-by: Jouni Malinen <quic_jouni@quicinc.com>
Handle the cases where the first attempt to start scan fails due to an
ongoing scan. Stop such scan and try again instead of failing the test
case immediately.
Signed-off-by: Jouni Malinen <quic_jouni@quicinc.com>
This avoids race conditions with UML time-travel where some cases ended
up not reporting the DPP-TX-STATUS event and that resulted in discarding
events that are more important to verify for correct behavior.
Signed-off-by: Jouni Malinen <quic_jouni@quicinc.com>
One of the sigma_dut testing cases missed the t.join() call to make
surte the separate thread terminated. This could result in confusing
"unexpected stdout output" in a middle of an unrelated test case.
Signed-off-by: Jouni Malinen <quic_jouni@quicinc.com>
