The Key MIC field is of variable length when using OWE, so determine the
correct length based on which group was negotiated for OWE during
association.
Signed-off-by: Jouni Malinen <quic_jouni@quicinc.com>
Check the +HTC bit in FC to determine if the HT Control field is present
when decrypting Robust Management frames. This was already done for QoS
Data frames, but the Management frame case had not been extended to
cover this option.
Signed-off-by: Jouni Malinen <quic_jouni@quicinc.com>
This is needed to derive the PTK correct when Secure LTF support is used
and the additional KDK component needs to be taken into account.
Signed-off-by: Adil Saeed Musthafa <quic_adilm@quicinc.com>
Commit b20991da69 ("wlantest: MLD MAC Address in CCMP/GCMP AAD/nonce")
updated AAD and nonce construction to use MLD addresses in AAD for A1
and A2. IEEE P802.11be has additional cases where A3 in AAD is set to
the AP MLD address, so cover those as well.
Signed-off-by: Jouni Malinen <quic_jouni@quicinc.com>
Commit 25b52e5f83 ("FT: Extend FTE parsing for FT-SAE-EXT-KEY") used
possible MIC length iteration to try to figure out the length of the MIC
field in FTE. That was the only option available at the time, but FTE is
now being extended in IEEE 802.11-REVme to explicitly indicate the
length of the MIC field for the new FT-SAE-EXT-KEY AKM to make this
easier.
Use the new design from the approved comment resolution (*) in
REVme/D2.0 ballot CID 3135 to simplify implementation. This gets rid of
the need to pass in key length and the somewhat strange need_{r0kh,r1kh}
parameters to wpa_ft_parse_ies().
(*)
https://mentor.ieee.org/802.11/dcn/22/11-22-1991-02-000m-proposed-resolutions-to-some-lb270-comments.docx
Signed-off-by: Jouni Malinen <j@w1.fi>
It is possible for there to be multiple STA entries (e.g., one for each
BSS) when a sniffer capture contains multiple associations using MLO.
For such cases, the new PTK information needs to be updated to all
existing STA entries to be able to find the latest TK when decrypting
following frames since the other STA entries might be located first when
trying to figure out how to decrypt a frame.
In addition to the PTK, copy the MLD MAC addresses to the other STA and
BSS entries to make sure the latest values are used when trying to
decrypt frames.
Signed-off-by: Jouni Malinen <quic_jouni@quicinc.com>
Provide AKM, key length, and information about needed subelements to the
parser function so that the variable length MIC field cases can be
recognized for FT-SAE-EXT-KEY. Knowledge about R0KH-ID/R1KH-ID being
needed is required to be able to iterate over possible MIC field lengths
for the case where the AP does not yet know the correct key length at
the beginning of FT protocol.
Signed-off-by: Jouni Malinen <quic_jouni@quicinc.com>
Provide AKM to the helper function so that the new SHA256 and SHA512
options can be covered for FT-SAE-EXT-KEY.
Signed-off-by: Jouni Malinen <quic_jouni@quicinc.com>
Extend wlantest capabilities to cover the new SAE-EXT-KEY AKM and
variable length MIC field and key lengths for it based on the used SAE
group.
Signed-off-by: Jouni Malinen <quic_jouni@quicinc.com>
Allow a single STA entry to be found for a non-AP MLD regardless of
which link MAC address was used to transmit/receive it.
Signed-off-by: Jouni Malinen <quic_jouni@quicinc.com>
Update STA state tracking for SAE authentication as well as the previous
covered Open System algorithm.
Signed-off-by: Jouni Malinen <quic_jouni@quicinc.com>
This makes the debug message more useful for determining whether an
expected BIGTK has been derived.
Signed-off-by: Jouni Malinen <quic_jouni@quicinc.com>
rx_mgmt_beacon() was skipping all steps after a Probe Response frame
from the AP had been processed. This is expected for the parts that were
updating the bss entry information, but the checks for beacon protection
should not be skipped in this manner.
Skip onlu the updating parts while checking that beacon protection is
used correctly to make this more useful.
Signed-off-by: Jouni Malinen <quic_jouni@quicinc.com>
Use the MLD MAC Address instead of link address in CCMP/GCMP AAD/nonce
construction when processing an individually addressed Data frame with
FromDS=1 or ToDS=1 between an AP MLD and non-AP MLD.
Signed-off-by: Jouni Malinen <quic_jouni@quicinc.com>
Do not complain about unprotected Action frames for additional
categories that have been defined as not being Robust.
Signed-off-by: Jouni Malinen <quic_jouni@quicinc.com>
Data frame processing had already been extended to support additional
cipher suites, but Robust Management frame processing was still using a
hardcoded cipher suite (CCMP-128). Extend it to support GCMP-128,
GCMP-256, and CCMP-256 as well.
Signed-off-by: Jouni Malinen <quic_jouni@quicinc.com>
This previously reserved bit is now used in FTM to help select the
appropriate replay counter. Silence the warning about use of a reserved
bit for this. wlantest does not yet support the actual replay counter
processing for FTM.
Signed-off-by: Jouni Malinen <j@w1.fi>
Use the TKs from the PTK file (-T command line argument) to try to
decrypt encrypted Management frames if no BSS/STA key can be found based
on addresses.
Signed-off-by: Jouni Malinen <j@w1.fi>
Extend the fils_pmk_to_ptk() to also derive Key Derivation
Key (KDK) which can later be used for secure LTF measurements.
Signed-off-by: Ilan Peer <ilan.peer@intel.com>
Extend the wpa_pmk_r1_to_ptk() to also derive Key Derivation
Key (KDK), which can later be used for secure LTF measurements.
Signed-off-by: Ilan Peer <ilan.peer@intel.com>
Verify that RSNE, MDE, and FTE have valid information in FT
Reassociation Response frames. In addition, decrypt GTK, IGTK, and BIGTK
from the frame.
Signed-off-by: Jouni Malinen <j@w1.fi>
It is expected for the STA entry on the target AP to move directly from
State 1 to State 3 when performing FT over-the-DS (i.e., FT Action
Request/Response frame exchange through the old AP followed by
Reassociation Request/Response frame exchange with the target AP).
Signed-off-by: Jouni Malinen <j@w1.fi>
Previously, missing CCMP protection on Robust Management frames was
reported based on the STA having indicated MFPC=1. That is not accurate
since the AP/BSS may have MFPC=0. Report this failure only if both the
AP and STA have indicated MFPC=1, i.e., when PMF has been negotiated for
the association.
Signed-off-by: Jouni Malinen <j@w1.fi>
If no Beacon or Probe Response frame has been seen in the capture, use
the IEs from EAPOL-Key msg 3/4 to set up BSS information.
Signed-off-by: Jouni Malinen <j@w1.fi>
The previous implementation tried to update STA IE information based on
EAPOL-Key msg 2/4 to be able to handle captures that do not include the
(Re)Association Request frame. This was not sufficient (OSEN was not
included) and was done too late (the parsed information is needed for
PMK-to-PTK derivation).
Move the IE update step to happen before trying to derive the PTK if no
(Re)Association Request frame has been seen.
Signed-off-by: Jouni Malinen <j@w1.fi>
Fetch the BIGTK from EAPOL-Key msg 3/4 and use it to validate MME in
Beacon frames when the AP uses Beacon protection.
Signed-off-by: Jouni Malinen <jouni@codeaurora.org>
Track PMK-R0/PMK-R0-Name from the initial mobility domain association
and derive PMK-R1/PTK when the station uses FT protocol. This allows
frames from additional roaming cases to be decrypted.
Signed-off-by: Jouni Malinen <jouni@codeaurora.org>
If a sniffer capture does not include FCS for each frame, but may
included frames with invalid FCS, it would be possible for wlantest to
try to decrypt the first received frame and fail (e.g., due to CCMP MIC
mismatch) because that particular frame was corrupted and then ignore
the following retry of that frame as a duplicate even if that retry has
different payload (e.g., if its reception did not show corruption).
Work around this by skipping duplicate frame detection immediately
following a decryption failure.
Signed-off-by: Jouni Malinen <jouni@codeaurora.org>
This part is missing from IEEE Std 802.11ai-2016, but the lack of DHss
here means there would not be proper PFS for the case where PMKSA
caching is used with FILS SK+PFS authentication. This was not really the
intent of the FILS design and that issue was fixed during REVmd work
with the changes proposed in
https://mentor.ieee.org/802.11/dcn/17/11-17-0906-04-000m-fils-fixes.docx
that add DHss into FILS-Key-Data (and PTK, in practice) derivation for
the PMKSA caching case so that a unique ICK, KEK, and TK are derived
even when using the same PMK.
Note: This is not backwards compatible, i.e., this breaks PMKSA caching
with FILS SK+PFS if only STA or AP side implementation is updated.
Signed-off-by: Jouni Malinen <jouni@qca.qualcomm.com>
Try to derive PTK when FILS shared key authentication is used without
PFS. The list of available PMKs is interpreted as rMSK for this purpose
and PMK and PTK is derived from that. If the resulting PTK (KEK) can be
used to decrypt the encrypted parts of (Re)Association Request/Response
frames, mark the PTK as derived so that encrypted frames during the
association can be decrypted. In addition, write a decrypted version of
the (Re)Association Request/Response frames into the output file.
Signed-off-by: Jouni Malinen <jouni@qca.qualcomm.com>
This adds minimal support for deriving keys for FT-PSK to allow the
initial mobility domain association to be analyzed in more detail.
Signed-off-by: Jouni Malinen <jouni@qca.qualcomm.com>
Remove the length field from struct ieee802_11_elems since the only
allowed element length is five and that is checked by the parser.
Signed-off-by: Jouni Malinen <j@w1.fi>
These functions did not verify that the received frame is long enough to
contain the beginning of the variable length IE area. A truncated frame
could have caused a segmentation fault due to reading beyond the buffer.
Signed-off-by: Jouni Malinen <j@w1.fi>
This modifies struct wpa_ptk to allow the length of KCK and KEK to be
stored. This is needed to allow longer keys to be used, e.g., with
Suite B 192-bit level.
Signed-off-by: Jouni Malinen <j@w1.fi>
This adds debug information from wlantest into pcapng frame comments to
make the information more convenient to use, e.g., in Wireshark.
Signed-hostap: Jouni Malinen <j@w1.fi>
These can be useful in tests involving association state mismatch
between the AP and the STA (i.e., STA assumes it is still associated
but the AP does not have association state). In such a case, the AP
would be sending out unprotected Deauthentication or Disassociation
frames with reason code 6 or 7 depending on what frame is triggering
this.
The Timeout Interval element needs to use Association Comeback time
for the case when (Re)Association Response frame uses Status Code 30.
Verify this before incrementing the (re)assocresp_comeback counters.
