diff --git a/src/common/qca-vendor.h b/src/common/qca-vendor.h
index a5bbc781a..7ccc4b438 100644
--- a/src/common/qca-vendor.h
+++ b/src/common/qca-vendor.h
@@ -3361,6 +3361,14 @@ enum qca_wlan_vendor_attr_config {
 	 */
 	QCA_WLAN_VENDOR_ATTR_CONFIG_QCA_PEER = 106,
 
+	/* 8-bit unsigned value to configure BTM support.
+	 *
+	 * The attribute is applicable only for STA interface. Uses enum
+	 * qca_wlan_btm_support values. This configuration is not allowed in
+	 * connected state.
+	 */
+	QCA_WLAN_VENDOR_ATTR_CONFIG_BTM_SUPPORT = 107,
+
 	/* keep last */
 	QCA_WLAN_VENDOR_ATTR_CONFIG_AFTER_LAST,
 	QCA_WLAN_VENDOR_ATTR_CONFIG_MAX =
@@ -16794,4 +16802,24 @@ enum qca_wlan_vendor_attr_fw_page_fault_report {
 	QCA_WLAN_VENDOR_ATTR_FW_PAGE_FAULT_REPORT_LAST - 1,
 };
 
+/**
+ * enum qca_wlan_btm_support: BTM support configuration
+ *
+ * @QCA_WLAN_BTM_SUPPORT_DEFAULT: Restore default BTM support policy. The driver
+ * follows the BSS Transition bit in the Extended Capabilities element from the
+ * connect request IEs with the default BTM support policy.
+ *
+ * @QCA_WLAN_BTM_SUPPORT_DISABLE: Disable BTM support for the subsequent
+ * (re)association attempts. The driver shall restore the default BTM support
+ * policy during the first disconnection after successful association. When this
+ * configuration is enabled, the driver shall overwrite the BSS Transition bit
+ * as zero in the Extended Capabilities element while sending (Re)Association
+ * Request frames. Also, the driver shall drop the BTM frames from userspace and
+ * the connected AP when this configuration is enabled.
+ */
+enum qca_wlan_btm_support {
+	QCA_WLAN_BTM_SUPPORT_DEFAULT = 0,
+	QCA_WLAN_BTM_SUPPORT_DISABLE = 1,
+};
+
 #endif /* QCA_VENDOR_H */